solemn skiff
So i bought the Rush tank 2 and i wired it up to my drone and i put it into betaflight and i put in the code thingy and im not getting signal to my goggles. Im new to this but i before i had a way worse VTX and it was working. Do i have to do anything else to set it up because im really confused. I have to pocket master radio, Beta fvp goggles, cherry 2 rush fvp antenna connected to the vtx, lumenier AXll rhcp connected to the goggles, and the speedybee f405 v3 flight controller
sharp apex
What is the "code thingy"?
cobalt rover
looks like the red wire for the vtx got shorted on the screw. notice the burn mark on the frame and the burn on the wire.
you have also wired the 5v out from the vtx to the 5v on the fc?
you also have 3d printed skids but you couldn't 3d print a camera mount?
also kind of looks like you have smart auto wired up to the vtx pad (video out)?
might want to completely rewire this
solemn skiff
do i see a blob of solder on the bottom right
no
solemn skiff
What is the "code thingy"?
that
solemn skiff
looks like the red wire for the vtx got shorted on the screw. notice the burn ma...
ya but before with the old vtx the drone worked and the this vtx still turns on so idk what to do
solemn skiff
do i see a blob of solder on the bottom right
solemn skiff
you have the blue and yellow wires the wrong way
ok i will try that thanks
wiat so @cobalt rover do i jsut swap the blue and yellow wires
cobalt rover
yellow goes to vtx and blue goes to t1
solemn skiff
ok thank you
@cobalt rover Thank you so much i am finally getting signal but i have to be like a foot away or the signal gets lost and in betaflight it still says device not ready
solemn skiff
@cobalt rover Nvm now it says device ready true but i still am only getting like a foot of signal and i tried lock a couple different channels
cobalt rover
is it in pit mode?
and did you power the vtx with no antenna at any point?
make sure the channel on the goggles and quad match
set it manualy dont use the search feature
