#i have the mobula 6 elrs 2024 edition and i accidentally reset the entire betaflight

35 messages · Page 1 of 1 (latest)

glossy coyote
#

Need help to get the mobula 6 back to its origional settings https://www.amazon.com/dp/B0D7GB1BSH?ref=ppx_yo2ov_dt_b_fed_asin_title

Happymodel Mobula6 2024 1S 65mm Micro FPV Whoop Racing Drone with C...

Mobula6 is a Tiny Whoop produced by Happy Model, designed specifically for indoor and FPV flight. MOBULA6 2024 ELRS Micro FPV Whoop is popular among drone enthusiasts for its lightweight body, performance, and ease of use. The Mobula6 is suitable for beginners to experienced unmanned drone player...

cedar copper
#

Copy/paste that into the CLI tab

glossy coyote
#

on the simulation it shows the drone spinning out of controlll

cedar copper
#

In the Receiver section?

#

You probably have the channel map wrong. You can change it, there should be a dropdown that says AETR1234 or TAER1234 or something. Change it to another option, you might need to save and reboot before it takes effect

glossy coyote
#

now when i try to fly and take off the whoop just flips and dies

cedar copper
#

Did you take off the propellers between the time it was flying normally and now?

#

If so, check that the correct propellers are on the correct motors. The props are directional, as are the motors

glossy coyote
#

it looks like when i tilt the quad left it goes up right goes down

#

so its fliped

cedar copper
#

Change the yaw offset to 180 degrees in the Configuration tab, maybe?

#

Don't forget to save (I always forget)

glossy coyote
cedar copper
#

Yes

glossy coyote
#

it didnt work

cedar copper
#

Did anything change? Or is it just wrong in a different manner now?

glossy coyote
#

nothing changed when i put yaw degrees at 180

cedar copper
#

That doesn't sound right 🤔

#

You should see some kind of difference if it's actually set

glossy coyote
#

yeah i dont know

#

are these relevant?

cedar copper
#

You should be able to leave those as default

#

It's odd that changing the board alignment did nothing though

#

You've calibrated the accelerometer already, right?

glossy coyote
#

i cant calibrate it quite right because my plug for the whoop is on the bottom meaning i cant place it leveled

cedar copper
#

Put it on the edge of the table to calibrate it

#

If you can put it over two things of the same height, you can stick the plug in the gap between them

#

Just hold the drone down firmly while calibrating

glossy coyote
#

fixed it

#

had to change this to 90

#

appreciate the help