river compass
Hello, recently i crashed my drone. The drone itself works as intended, but the camera doesn't display the image to the goggles. After disassembling it, I found the wire that is connected to nothing and I have no idea how it should be connected. Is there a way I can solder it? Thank you in advance.
mellow heron
Hello, recently i crashed my drone. The drone itself works as intended, but the ...
do you mean that wire?
in which case thats the rx antenna and isnt supposed to be connected to anything
do you have osd with no picture or nothing at all?
river compass
do you mean that wire?
Yes, that is the only i think which i see is connected to nothing
river compass
U mean what goggles show after powering on?
mellow heron
yes
river compass
mellow heron
one of the wires between the camera and the vtx is likely broken, i would peel back the black silicone on the back of the camera and see if any wires are loose
it a common problem
then just solder it back and reflow the others for good measure
the wire can also break at the plug so you might need to cut the plug off and solder it directly to the vtx
river compass
well i just adjusted the plug to which the wires were connected and it works now
i also removed the silicone on those wires, should i replace it?
mellow heron
well i just adjusted the plug to which the wires were connected and it works now
mine would be intermittent when i wiggled the plug and then eventually stopped working altogether
mellow heron
i also removed the silicone on those wires, should i replace it?
a blob of hot glue would work
or if you have something better
river compass
Okay thank you so much, really appreciate
mellow heron
you might end up having to cut the plug off
if you crash and the video goes again then you know the first place to look
river compass
The wires are fine, the plug itself is just a little bit loose and after poking it with a finger it tends to sometimes disconnect