#air65 not binding

26 messages · Page 1 of 1 (latest)

still tulip
#

I have a radiomaster pocket elrs and a air65 both out of the factory and they are not binding even when i sent a binding request though betaflight any help?

#

ikeep trying to change it to exprtesslrs but it dosent' keep it on the save and reboot

still tulip
#

hi yaros

peak fable
#

You should try binding using the WebUI (inputting the binding phrase)

Short version of it here:
0. Turn off everything

  1. Turn the pocket, go to the ELRS Lua Script -> Wifi Connectivity -> Enable WiFi (the first option)
  2. On your computer or phone connect to the network ExpressLRS TX, the password is expresslrs (all lowercase)
  3. Go to the browser and go to http://10.0.0.1, find the Binding Phrase input textbox, type a "password", whichever you want, but it has to be 6 characters or longer, you must remember it for later.
  4. Click Save, an alert will pop up, tap close.
  5. In your pocket tap the RTN key until you get back to the main screen, then power down the radio
  6. Plug in drone into USB or battery, let it sit for more than 1 minute, you will see the slowly-flashing LED start to flash very fast, this will activate the WiFi on it
  7. Connect to the ExpressLRS RX network, password is expresslrs
  8. Go to http://10.0.0.1 in your browser, find the Binding Phrase box, and type the same "password" (phrase) that you did in the other page (of the remote)
  9. Tap save, disconnect from WiFi, then power down the drone.
  10. First turn on the pocket, shortly after plug in the drone into USB, go to Betaflight Receiver tab, it should be bound
still tulip
#

WORKSSSSW ❤️ TYANK YOU

peak fable
#

No problem!!

still tulip
#

also how do i setup modes

#

:p

peak fable
#

In your pocket, do you use the default model? (called POCKET)

still tulip
#

specifically find out which aux is which

#

i have every buton linked to a mix/output

peak fable
#

Oh ok

#

In the receiver tab you can move a switch and see which channel moves

still tulip
#

oooh oke awesome

peak fable
#

Right here

image.png
#

By ELRS convention, arming should be always mapped to AUX 1, for safety reasons

#

If you want to put it on another physical switch, it is better if you remap it to AUX1 in your controller (that's channel 5 in EdgeTX)

#

But other than that, it doesn't matter, everything else can be on whatever AUX channel you like

still tulip
#

just flied for the first time

#

fucking awesome

peak fable
#

Oh niceee

still tulip
#

how does crash after flip mode work

#

i turn it on and arm and it dosent do anything

peak fable
#

You have to turn it on, arm, and then roll or pitch