#help with EV800D / mobula 7 [SOLVED]
47 messages · Page 1 of 1 (latest)
any help?
theres no battery plugged in during this clip?
no
its best to show with a battery
1 sec
what voltage are you expecting it to show up at?
fly one down to around 3.3 and then send a picture
also i wouldnt fly under 3.3
i land at around 3.4
okay so i should put the warning at?
wait maybe everything is alright i put it so the low battery text would appear at 4.20 and the battery was 4.06 and its said low battery!
so i think everything is alright.
but should i change any setting here?
change minimum cell voltage to 3.4
you really shouldnt fly under 3.3 and 3.4 is what i land at because it gives a little bit of time just incase
okay
and warning at 3.6
if you fly them to low the batteries break and you cant use them anymore
okay
and have a chance of exploding/fire
Draining lipos too far definitely damages them, but isn't going to start a fire
Dead shorts, over charging, or cell puncture can start fires though
@grim ledge have you read Oscar Liang or Vitroid's lipo safety guides?
no
i ain't reading allat
I ain't helping then
OKAY AM READING AM READING SORRY
so what will happen if i charge an LiHV battery with LiPo charger
?
help with EV800D / mobula 7 [SOLVED]
Nothing, it'll just stop charging at 4.2V instead of 4.35V
Just means you won't get the rated mAh from the pack, because you'll be starting at 85% capacity
mhm...
i dont know, i got an GNB battery that on it 3.8V (nominal voltage) , and there is also a text: HV 4.35V so i dont know should i chage it to 4.35V or 4.20V
It is rated to charge to 4.35V