#Gyro calibration goes off after arming causing flips when roll is applied (Motors & props correct)

8 messages · Page 1 of 1 (latest)

high current
#

I have new build with a F722 Mk4 mini controller and sometimes when it is armed it will do take off flips when only roll is applied while it is on the ground. I went through BF and set up the motors and props correct and Re-calibrated accelerometer however after 2 flights I replaced the battery and when armed I applied roll and it did a start flip. I checked the BF setup and it shows the drone tilted all the way to one side an needed another calibrate accelerometer. Why is it getting tilted?

thumbnail_image0.jpg thumbnail_image2.jpg thumbnail_image3.jpg
formal moss
#

Firstly, do not run that wiring harness over the flight controller. It can cause issues like this.

#

Second, could I get a video of this happening?

#

Maybe even a blackbox?

high current
#

On angle mode the drone shiuts down when flipped

#

its like having the motors on the wrong way but its the actual gyro going into a different (tilted Calibration)