⛑️help-with-drones
strange yaw noise
[SOLVED]
[PID's]
Quick question [RESOLVED?]
Am i just a whiner or is something wrong
EV800 Goggles cut out of 20-30 feet of video feed while flying quad.
Searching Charger for Drone
does anyone know how I can remove this little clip at the bottom of my motor?
Correct Electronic layout?
Troubles binding my Drone
[SOLVED]
Is 35a 4 in 1 esc not enough for 6s
4mm shaft props for drone
Generative Ai Frame Optimisation
Bind CRAZYBEEF3FR SPI FrSky RX to QX7
Help building drone; beginner
No ESC start up sequence
problem with esc
Long-range transmission idea
potentially bought the wrong antennas
[SOLVED]
OSD Issues. [SOLVED]
[SOLVED]
I need help binding to elrs.
Smoked a Motor by Testing it in Alpha
Connecting DJ RC to pc for acro sim usage
Help with DIY Drone and BVLOS
[Ardu-INAV-Pixhawk]
[SOLVED]
[Fixed wing]
VTX Will not power on but gains tempurature.
Enabling LED and Barometer on FC
TX12 Connects To Quad, shows connected, but no switches or controls work..
moving the sticks on zorro controller but nothing happens
Does anyone know how to use a SD card with a tx16s correctly?
Building my own 3inch
Need advise/help
Building a light-ish drone that can handle small payloads
Looking For Good Anntena 5.8G
VTX ready no in Betaflight
DJI goggle v2 antenna recommendation
radio master zorro
my toothpick flys away when I arm
problem with happymodel aio vtx
hi what is the best esc and motor combo for a 2s hovercraft
no betaflight inputs when reciever connected to radio [SOLVED]
crazybee f4 frsky v3.0 to elrs rp2 receiver
Buying a 5-inch
Board detection problems post-flashing
Board won’t connect on betaflight or inav
DJI O3 cutting out and OSD freeze
A guy is selling these parts, I can't find much info about them
Good Indoor Whoop Shopping list help
Help flashing Betaflight firmware
TX16S charging power supply
drone wiggles? uh oh
VTX table for mobula8 analog
[SOLVED]
Buying a 5-inch setup