keen bison
I'm putting a replacement motor in my 95 legacy, everything is together and it refuses to start.
Things I've Checked/Tried:
The car backfired out the intake when we used starter fluid
The motor is from one of my other cars so I know that it ran before pulling. The only difference is I'm using a non EGT intake (because this car didn't have EGT)
harsh path
crank gear and cam gears swapped from the 95?
there are a few different versions depending on what your motor was removed from
keen bison
I'm fairly sure it was removed from a 96 impreza OBS. I checked the crank gear and it looks identical. I'll look into the cam gears maybe, but I'd assume they're the same because it's still dual port heads
keen bison
Crank gear looks identical. And so do the cam gears :/
(Black one is from the 96 motor)
blissful isle
Those aren’t the gears
You care about the part with the teeth for the cam/crank position sensors
harsh path
no missing teeth on the crank gear?
if i’m remembering correctly you should have an RPM reading while cranking, it’s barely getting fuel so i’d verify that you 1. are getting 12v at injectors and 2. actually have fuel pressure and ideally that your crank position sensor is functioning correctly
keen bison
I figured it out, I'm an idiot and didn't clean my crank gear very well so I was using the wrong timing mark...
blissful isle
Thankfully that’s a non interference