Printer setup | VORONDesign | Page 1

balmy gulch Apr 5, 2026, 9:12 AM

#

I have been using my printer for about 2 years with no problem. I did a firmware update and bricked Klipper, so fun. The upside is I went in and copied out all of the config files before mucking it up.
Starting over, I use Pi Imager. Pi OS Lite 64-bit. Then SSH'ed in using Kiauh, I installed in order loaded Klipper, Moonraker, Mainsail, KlipperScreen.

Took some effort but got it running but it doesn't boot like what I expect. And it shuts down in the middle of prints for no apparent reason. Haven't gotten a good print out yet.

Any help is appreciated. Attached latest Klippy and Moonraker logs.

📎 moonraker.log 📎 klippy.log

vernal laurel Apr 5, 2026, 10:45 AM

#

No significant errors in either log.

When it shuts down mid print are you able to SSH into the pi?

Can you expand on "doesn't boot like what I expect"?

balmy gulch Apr 5, 2026, 11:37 AM

#

When it first boots it hits an error and then reboots and finally starts KlipperScreen. Its hard to catch because its just Pi starting on the small screen.

#

On the printer screen, its asking for a Pi login, sits for just a second then screen goes blank. Then it reboots and gets in the second time.

#Printer setup