#v0.2 TMC 'stepper_z' reports error: GSTAT

4 messages · Page 1 of 1 (latest)

marsh depot
#

so i got my voron zero kinda working and i got a few prints done on it, but i installed a .8mm nozzle and i was printing something and twice it stopped at a different height and gave this error, TMC 'stepper_z' reports error: GSTAT: 00000001 reset=1(Reset) , it stopped the print both times, im not sure how to fix it, its a btt skr e3 turbo with tmc 2209 steppers that are soldered on, i dont think its overheating, i doubt its a power thing, and the z axis works and hasnt had issues before, its sensor less homing on x and y but it has a physical endstop on the z axis. for the run current it was at .2 and i brought it up to .4 and it stopped sooner but with how small of a current it is im not sure if its that either. any help would be great, i keep getting errors similar to this and its been hard to get complte prints (side note, i have a btt pico i can switch to if its a board issue)

marsh depot
#

i printed a tall box in vase mode after and it failed but with a extruder tmc error, ths klippy log has all 3 fails, if you search garbage that is when it happens each time i think

📎 klippy_3.log
#

considering this has happened so many times could this be a motherboard problem?

halcyon arrow
#

https://klipper.discourse.group/t/tmc-stepper-reports-gstat-00000001-reset-1-reset/19801

lots of potential causes. difficult error to track down the cause of.

Klipper
TMC 'stepper' reports GSTAT: 00000001 reset=1(Reset)

TMC ‘stepper’ reports GSTAT: 00000001 reset=1(Reset) Background During the startup phase of the printer, the relevant TMC driver registers are programmed by Klipper. This includes, but is not limited to, run_current, microsteps, etc. During printer runtime, Klipper periodically reads back the current state of the TMC drivers. If it finds th...