little oracle
I think I have it reasonably tuned and built, but I'm wondering if there's more I can do to eek out a bit more performance before going to monolith soonish.
Mods: Beacon (used for ADXL), Jabberwocky, BFI, GT3 belts
Belt Tension: I'm using the belt tension tool from West3d
Ran out of room for more pics
dusk summit
I think I have it reasonably tuned and built, but I'm wondering if there's more ...
Cube looks good
Graphs looks good
If u go monolith anyway, dont change things
little oracle
I'm gonna change things, but I'm also gonna put the effort in to get a similar level of calibration. Although i need to figure out whats going on with my first layer
dusk summit
I'm gonna change things, but I'm also gonna put the effort in to get a similar l...
I dont see any need for help from us if u change to monolith anyway 👍
little oracle
Nothing to help with accels in the meantime? I get that it's a 350 with 2wd so it's gonna be slow
dusk summit
Nothing to help with accels in the meantime? I get that it's a 350 with 2wd so i...
If u upgrade anyways i honestly dont see the need to put work into this
dusk summit
I think I have it reasonably tuned and built, but I'm wondering if there's more ...
The x backer is installed wrong btw
It must always be on the opposite side of the linear rail to counter it
dusk summit
I think I have it reasonably tuned and built, but I'm wondering if there's more ...
And install galvanics arm #1308097646786777108 message
but as i said, prints looks good. I would keep everything as is and start printing Monolith parts
little oracle
The x backer is installed wrong btw
It must always be on the opposite side of t...
oh shit you right