#went to start a print and it just died on me

6 messages · Page 1 of 1 (latest)

oak hill
#

went to go print a flow calibration errored out and now its stuck like this i have cleared logs and restarted printer and now it stuck.

📎 moonraker.log 📎 klippy1.log
solid kiln
#

I don't know much about CANbus, but it seams like a communication issue. I'd check the wiring to make sure you don't have a broken one. My toolhead USB cable failed on me after 200h print, which I had to replace. So I'd give it a try

oak hill
#

it is running a Manta M8P and the MCU is the main board.

oak hill
#

fixed it, didnt have the brain power when i was doing it something about been tiered.

#

Fixed by removing all can connetions and removing can addresses in printer cfg.

#

then i reset the manta with the reset switch