Trident Second Peak in X

[proud cedar]

Mods:
-Chaotic Tap
-SSB2209 CAN
-Galvanic Umbilical

I already tried putting it on the ground

Question: Where does the second spike in x come from.

[unkempt fossil]

hello

Your cube looks like you might need some PA adjustment

what are you using for your input shaper settings

the x-axis double peak could be a loose screw in the toolhead, or a loose screw in the x-carriage (CL tap) or a loose screw in the xy joints

the 125 hz stuff could be your CL tap

[proud cedar]

Thank you for your input. I didnt tune my print settings yet, just wanted to print the cube since its requiered and maybe there is something to see anyway.
will hunt for a loose screw.
the 125hz doesnt bother me as much.

[unkempt fossil]

the 125 hz could be the problem. A loose screw on x-carriage is your CL tap

[proud cedar]

no change after checking all screws

[unkempt fossil]

did you double check the screws on the xy joints

leave the screws on toothed idlers be. They do not look to tight

[proud cedar]

Yes i checked every screw on the X-Axis. only "loose" was the one on the left for the toothedidlers. didnt tighten it

[unkempt fossil]

it is up to you what you want to do

you are getting EI on both x and Y, with y's accel in the solid normal range for a trident

I think with some PA tuning the artifacts on the cube will go away

[proud cedar]

If there are no more clues then "maybe a loose screw" i think i can live with it. The printers are for students and most wont notice the time i put in to hunt little things like that

thank you for helping me

[unkempt fossil]

It could also be umbilical potentially.
But, it really comes down to how much time you want to chase it

[proud cedar]

the rest of the evening 😂

[unkempt fossil]

oh then I would look at the umbilical

[proud cedar]

what exactly should i look at? i have the same mod for the other printers and there arent these problems

[unkempt fossil]

https://youtu.be/IzYNO515-M0

[proud cedar]

so you are saying in the video that how i route my cable after the cablewhip has an influence?

[unkempt fossil]

Cable routing definitely makes a difference

[sacred plank]

Its been 10 days. Any update for us? Do u want us to mark this as SOLVED?

[proud cedar]

i tinkered the rest of the evening and didnt get a improvment. so its kinda solved

[sacred plank]

Send us please updated pictures of your printer

Front of the entire printer