Hello, I can't connect my BTT Pi 1.2 with the MCU BTT SKR mini E3 V1.2.
I have installed the Recommended SO to the BTT Pi, flashed the SKR mini following the instructions, and modified the printer.cfg using the file for this MCU published on Klipper's Github. they are connected via USB
But always shows "Unable to connect", and in the klippy log shows "mcu 'mcu': Unable to open serial port: [Errno 2] could not open port 35FFD6054247343120830157: [Errno 2] No such file or directory: '35FFD6054247343120830157'"
#Can't connect BTT Pi 1.2 with BTT SKR mini E3 1.2
jade cove
unreal crown
what is "35FFD6054247343120830157" ?
is that some random fragment of the ls /dev/serial/by-id/* output?
if so, you've cropped it far too tight. it should be the whole line
jade cove
what is "35FFD6054247343120830157" ?
Yes, this is a part of the complete output, i cropped it in a try to solve the problem. originally was: /dev/serial/by-id/usb-Klipper_stm32f103xe_35FFD6054247343120830157
unreal crown
Yes, this is a part of the complete output, i cropped it in a try to solve the p...
Even that is incomplete
Look again
There's normally an -if00 on the end of that