Hi from Chile! Just received my voron trident kit from formbot ! For now I advanced what I can while I wait for the 3D printed parts to arrive.
In the mean while, I like to ask what is your opinion on the formbot metal TAP mounting?
#Formbot Voron Trident R1 Pro
distant imp
rancid meadow
distant imp
Hi ! My PIF should arrive next week, what should I advance in the mean time?
For now I just cleaned the linear rails
Other question, I bought the TAP upgrade with machined parts, it come pre assembled, should I disassemble it, clean and grease the linear rail ?
distant imp
I quick update:
All linear rails were cleaned and now greased
I did the connections from AC to UPS to moderboard, installed CB1 on the Manta, flashed the OS.
Had a little of trouble with the Wi-Fi connection, the board didn't showed on my router, so with a help from Klipper discussion channel, I did the following
C9nnected with ethernet to the router, then it showed up, installed kiuah, updated all, configured the board, got the serial and firmware files. Then to the board SD card.
For the wifi connection used the nmtui command to configure the wifi and all worked out.
Next steps while I wait for my PIF to arrive: configure file and CAN
distant imp
Quick update,
Fairly advanced with the config, and flashed katapult onto the main board, following the esoterical guide.
Next step to flash the toolhead can board
Next weekend should I also have the printed parts
distant imp
A & B drive and idler ready
distant imp
Quick update, AB drive, idlers and Y linear rails installed in the frame
distant imp
Hi! Quick update, ready with the z axis and feet !
distant imp
X axis installed
distant imp
Belts, stealthburner, TAP and CAN ready
distant imp
Build plate done, starting with the wires
distant imp
Done with the build, now into the initial starup process
