#E3D PZ config

30 messages · Page 1 of 1 (latest)

primal goblet
#

Hello, would someone help me to configure e3d pz probe in klipper? i pasted the file from E3d into my printer.cfg file but im getting errors

#

here is my printer.cfg

slate basalt
#

It tells you the issue.

pin: nhk:gpio12
x_offset: 0.0
y_offset: 0.0```

That's part of the current config and as the error says it doesn't contain a z_offset.
#

Is this a new printer build?

primal goblet
uneven relic
#

You could probably start with a z_offset: 0.0 right next to those.
It will need to be calibrated regardless of the type of probe, but since that one will hard crash if it doesn't work right you might want to have it probe on something other than the print surface when testing it out.

primal goblet
#

okay, when i have done this, it blamed me for invalid position or something like that

slate basalt
#

You haven't set up your safe_home section.

primal goblet
#

#position_endstop: 0.0

slate basalt
#

Best to actually show us the errors you get.

primal goblet
uneven relic
#

Also probably worth checking out the config for a TAP (which also probes using the nozzle). It usually makes sure the nozzle isn't too hot by limiting the temperature to 150°C or so (and wait for it to cool down before probing). A fully heated up nozzle can easily leave marks on the build plate.

primal goblet
#

i tryed to home

#

and i got this error

slate basalt
primal goblet
#

okay, i figured out that my probe is inverted, when its triggered, klipper says its open...

#

how can i change it?

#

pin: nhk:gpio12

slate basalt
#

If you are following the initial startup it tells you how. Click the troubleshooting section.

primal goblet
#

when i have done pin: !nhk:gpio12 moonraker was unable to comunicate with nhk

slate basalt
#

Did you read this note?

Tap acts as a “virtual endstop”. This functionality will be tested in a later step, so the Z endstop may be safely ignored for now.```
#

Remember EZ acts in the same way as Tap.

#

I need to go to work now, hopefully someone else and someone with EZ experience can assist you more.

primal goblet
#

thank you and gl

primal goblet
#

okay, i dont know what to do, my bed just dont want to go up by any chance