Y Axis Graph all over the place | VORONDesign | Page 1

neon oracle Jun 23, 2025, 12:12 AM

#

Hello, I'm doing input shaper for the second time since I changed my extruder from CW2 to Galileo 2. The X graph came out fine but the Y graph is coming out all over the place. Any idea on how to fix this?

Voron 2.4 350mm
Stealthburner with Galileo 2 & Beacon
Fystec ADXL 345 mounted in front of Stealthburner
GT2 Belt Tension Meter

#

#

#

lunar swan Jun 23, 2025, 12:25 AM

#

hello

#

what does belt shaper look like

neon oracle Jun 23, 2025, 12:26 AM

#

I think it looks good?

neon oracle Jun 23, 2025, 12:47 AM

#

So I noticed the heat inserts on the x carriage got a little loose which leads me to believe that it has an effect on the y axis input shaper. This is the 3rd time the heat inserts got loose which I've had to print new parts for. Is there a mod that uses nuts as attachment rather than relying on heat inserts?

lunar swan Jun 23, 2025, 1:21 AM

#

neon oracle So I noticed the heat inserts on the x carriage got a little loose which leads m...

If those, or any heat sets, are loose then it will have an effect

neon oracle Jun 29, 2025, 10:55 PM

#

#

#

After fixing the issue on the x carriage, I ran input shaper again and got these new graphs. X graph looks fine again. Y graph looks a lot better than before but not the best.

Does the Y graph highlight any serious problem or should I proceed with applying the recommended frequencies to my config?

lunar swan Jun 30, 2025, 12:57 AM

#

Can you post an updated picture of the front of your printer please

neon oracle Jun 30, 2025, 1:25 AM

#