Just started doing this one day, sounds like it gets worse each print
#Squeeky z axis
formal shard
marble geode
mostly sounds like stepper driver noise rather than mechanical noise
opal ridge
Just started doing this one day, sounds like it gets worse each print
btw, it appears you have your x axis cable chain back-to-front
the fixed end should be attached to the toolhead
your z axis cable chain looks....odd
you should also secure those loose wires at the back
formal shard
btw, it appears you have your x axis cable chain back-to-front
the fixed end sh...
my chain is a cheapo one, as is the rest of the kit i got, chains are weird because the pins that hold them straight dont work
formal shard
mostly sounds like stepper driver noise rather than mechanical noise
listen to 13 seconds in
marble geode
so yes the noise does change at the front right, ok
i would examine that corner- belt tension, z-drive belt tension, alignment
opal ridge
Just started doing this one day, sounds like it gets worse each print
what method did you use to tension the belts?
formal shard
errrr... luck, the whole microphone thing never gave peeks so i just did... someting
opal ridge
errrr... luck, the whole microphone thing never gave peeks so i just did... some...
hmmmm, luck is probably not the best method 😆
acquire/build one of these, makes tensioning correctly easy
formal shard
👌will look into, ya think tension is to do with the noise? i was thinking its something to with the rails needing lube or sumthn
marble geode
very possible, yes
opal ridge
👌will look into, ya think tension is to do with the noise? i was thinking its s...
did you clean and re-grease before you installed them?
formal shard
nope
marble geode
this printer has an afterburner, how old is it?
formal shard
i got the kit in 2022 finished assm in 2023, it was a formbot kit... that they discontinued because its sorta crap
opal ridge
this printer has an afterburner, how old is it?
same age as mine 😜
opal ridge
i got the kit in 2022 finished assm in 2023, it was a formbot kit... that they d...
afterburner is fine, i'm still running with it
formal shard
i have 5015 for making sb or... soemthing, wanting to go higher flow, but havent had much luck geting abs to not warp so havent done
marble geode
yeah i'm not casting shade on the toolhead was just curious as to how long it had been printing or if it was second hand
marble geode
no grease during assembly?