#Which kit to buy?

12 messages · Page 1 of 1 (latest)

indigo dagger
#

I plan on building a Voron 2.4 but there’s so many different kits at so many different prices and I don’t have the biggest budget so I’m looking for a kit that’s on the cheaper end but is still reliable

tardy edge
indigo dagger
#

That is very helpful thank you

tardy edge
indigo dagger
#

Yeah, that’s the one I was looking at now cause I looked at it earlier, but wasn’t sure if that reseller was reliable but from whatever I’m seeing looks good

#

I was also looking at 3-D printer bay because it looks like you can customize your items a little bit better there

tardy edge
indigo dagger
#

All right, thanks for the heads up, man

lusty garnet
#

I think 3D printer bay is just repackaged formbot kits. Not sure if it's worth the extra money for the customizability.

granite dome
#

I built a Siboor kit at the end of last year and was overall satisfied. Everything was well packaged and there was a minimum of changes to the instructions. The wires were all pre-crimped but there was 1 or 2 of them that I altered to use the wago power distribution instead of how they were crimped.

I think the only problem I had was the Stealthburner LEDs didn't work. I'm not confident that was a "them" problem though because I very well could have damaged them.

tacit tinsel
#

Any updates on this question?

I have seen such a huge price difference between the LDO Motors Kit and the Formbot Kit, and curious if that is justified or best to just go with Formbot?

I want to get the 350mm 2.4

fringe ether
#

imo go with Formbot, quality was totally fine with my kit, and the price difference to LDO leaves a LOT of room for upgrades later on