tight harness
I again tried following the guide, but am unable to get past this step myself..
printer.cfg:
[include btt_canbus.cfg]
the (sample btt config) btt_canbus.cfg this:
sensor_type: ATC Semitec 104GT-2
sensor_pin: EBBCan:gpio27
But when starting Klipper throws this error:
MCU 'mcu' shutdown: ADC out of range
Sensor 'extruder' temperature -49.702 not in range 10.000:300.000
I have it wired to TH0, 2 wire Bambu Lab Themristor that worked with this config before CAN conversion.
mint maple