This is my First Voron Printer, and my third printer overall. The parts for this build will be printed on an enclosed anycubic kobra 3.
#Formbot 350mm V2.4
valid umbra
Today, I purchased the kit. Will update more when I buy filament or when the kit arrives
valid umbra
Kit got here!
prime oak
valid umbra
Thanks!
carmine iris
Welcome, just finished building a Formbot 2.4. Reach out if you get stuck. Not sure I have all the answers, but I might be able to help
valid umbra
On the EBB SB2209 RP2040, which fan voltage connection should I bridge for 24v fans?
valid umbra
I figured it out, it’s the VIN pins
valid umbra
Ordered filament, should be able to start printing tomorrow!
valid umbra
Prints have officially started
valid umbra
A few defects from warping here and there, but other than that, prints are going well
carmine iris
Looks good, how did you do the pattern? Multimaterial?
valid umbra
Looks good, how did you do the pattern? Multimaterial?
yes, I used this model: https://www.printables.com/model/592063-hex-pattern-stealthburner-face-as-a-single-model-m and a Kobra 3 with ACE pro
valid umbra
Frame, idlers, and z drives are all done!
valid umbra
Quoth the Raven “Nevermore”
valid umbra
Also installed the bed
valid umbra
Gantry is finished and installed!
valid umbra
Electronics, tap, and stealthburner are ready for testing!
