Extrusion problem | VORONDesign | Page 1

small gorge Apr 7, 2025, 4:18 PM

#

Hi all - I'm having an extrusion issue. Ive tried multiple things including taking apart the head, cleaning everything and reassembling. I cleaned the hotend and put a new nozzle on too. Not sure what's causing this and appreciate some ideas of things to look into. See attached vid.

dire knot Apr 7, 2025, 5:23 PM

#

With the movement it looks like the gearing has a good hold, so probably a blockage in hotend, not hot enough or extruding too fast - although it didn't look that quick..

#

Ps. With a profile pic showing your a cyclist, your lucky I replied 😀

small gorge Apr 7, 2025, 5:44 PM

#

Thanks Broski. I'll check those things again. I better change my profile pic... BTW, almost exclusively indoors and trails nowdays...

small gorge Apr 7, 2025, 6:10 PM

#

FIlament feed was way too fast. Needed that second set of eyeballs on it. Thanks Broski.

dire knot Apr 7, 2025, 8:52 PM

#

Just keep off the roads 🤣

#

Joking though, always give loads of romo or stay behind

small gorge Apr 7, 2025, 8:54 PM

#

Cars and trucks vs bikes. We know who wins....

dire knot Apr 7, 2025, 8:55 PM

#

Bikes when the popo turn up..

#Extrusion problem