config file for reference
#difficulty resolving multiple config errors (M8P v2 with sb2209 rp 2040 toolhead)
mortal totem
Line numbers are generally misleading in klipper due to how it deals with includes
They should be ignored, and just look for the problem content
This line is a comment
Aka, should begin with #
Same story here:
By contrast, these two lines are not comments, and need their # removed
There's a bit of a convention in these files, when a section is commented out, that anything functional will have ONE #, vs anything that's actually comment will have ##
Thus, when uncommenting a section, remove a SINGLE # from each line, and if somethings are still comments, it's because they're supposed to be.
whole hearth
okay, so that cleared up, thank you
its now angry at me for new and exciting reasons
its mad at me for assigning pc13-pc15 twice, not sure what to do cause this is the stock config for M8P. i also cant even find pin pc13 on the board specs
cannot find these pins
mortal totem
What is heater_fan fan4?
By which I mean, what do you have plugged into that port? Why do you have that config section enabled?
whole hearth
im attempting to get the all the fans not on the toolhead pcb there