#2.4 300mm, need to improve print quality.

1 messages · Page 1 of 1 (latest)

fiery garden
#

@old island take a look at the following https://youtu.be/IzYNO515-M0?si=mmU788osVpmbIHG3

xy_joint.jpg
YouTube
Reth
Umbilical Routing for Trident and V2

How to route your umbilical: Three ways for Trident and three ways for V2.
Special Thanks to Schonclee for asking the question about which umbilical routing is preferred.

V2 starts about at about 6:30

Galvanic Bowden tube Guide (use the short arm for Trident, and the long arm for V2):
https://mods.vorondesign.com/details/8CxQeqS1lXhlGphwkyqh7g...

▶ Play video
#

The prefered method to testing belt tension is the pf makes tension tool

#

Your belt tension is off. I am not sure if it is low or high. How are you currently measuring it?

fiery garden
#

I am not going to say that it is the best way, but it is a better way than your current setup

fiery garden
#

you shouldn't need a wire in the umbilical

fiery garden
#

I didn't know the wire was built into the cable

#

leave that