Voron Trident Y Axis Issues | VORONDesign | Page 1

vagrant bone Dec 4, 2024, 11:38 PM

#

Check your XY joints according to the attached picture

#

Once done, rerun all 3 measurements
X
Y
Belts

#

And while u wait for the test to run, make sure to click on your flag in #rules 👍

#

Your long umbilical is also a problem

#

Remove that tubing thing. Use galvanics thing https://www.printables.com/model/978123-voron-bowden-ptfe-tube-guide-arm-and-canbus-cable

#

And i would recommend to run it out of the exhaust instead

#

How do u tension belts? By ear, by app, with a tool? Etc

#

If by app to which frequency

#

Are u using TMC autotune? See link from bot below if u dont know it yet

sturdy sinewBOT Dec 4, 2024, 11:47 PM

#

@gusty orchid https://github.com/andrewmcgr/klipper_tmc_autotune

stone maple Dec 5, 2024, 2:28 AM

#

I think we need to start looking at umbilical

#

It is better to use the fiber cloth stuff over the corrugated tubing you are using

#

Take a look at my video on umbilical routing https://youtu.be/IzYNO515-M0?si=DO9NFoLSextf9Ark

YouTube

Reth

Umbilical Routing for Trident and V2

How to route your umbilical: Three ways for Trident and three ways for V2.
Special Thanks to Schonclee for asking the question about which umbilical routing is preferred.

V2 starts about at about 6:30

Galvanic Bowden tube Guide (use the short arm for Trident, and the long arm for V2):
https://mods.vorondesign.com/details/8CxQeqS1lXhlGphwkyqh7g...

▶ Play video

#

stone maple Dec 5, 2024, 3:04 AM

#

It is better to have umbilical follow the Bowden. Take a look at my video I have an example

#

Can you run an updated input shaper for your tweaks

#Voron Trident Y Axis Issues