I have a vzbot 330 AWD. I'm hoping to get a little insight in the test results from someone more experienced. This started out as an ender 6. I have a trident on the bed. ADXL was used to generate results.
#Vzbot help
tidal heart
I have a vzbot 330 AWD. I'm hoping to get a little insight in the test results ...
Just so u know, this is the VORON discord and the #1308016330326413393 (has voron in its name), so dont expect too much here as our knowledge is and will only really work on Voron printers. We can check the basics but not go into a deep dive
tidal heart
I have a vzbot 330 AWD. I'm hoping to get a little insight in the test results ...
also i dont know what "I have a trident on the bed" means
spring musk
Any help you can give would be appreciated.
I used the black widow trident mod, I’m pretty sure I found here in the voron forums.
tidal heart
Any help you can give would be appreciated.
u definitely have to check your belt tension. And we need a picture of the front of the machine, as required in the guidelines
spring musk
heres the front.
untold flicker
We can offer very limited help with a vz bot.
One of two things looks like it is happening: either your a belt is to tight, or your b-belt is too loose.
You might have tighten one belt all the way instead of a little on each belt going back and forth
@tidal heart you beat me again.
tidal heart
<@300652444453437440> you beat me again.
I cant beat u in terms of knowledge, so i gotta be faster 
doing the 1st level support things 
untold flicker
I cant beat u in terms of knowledge, so i gotta be faster <a:hehe:88090257000302...
I do not believe that for one second
spring musk
@untold flicker fair enough. if you have any advice on these results, I'd love to hear it. I'm still getting a vibration when turning corners at anything above 100 mm. I'm seeing the cross belts isn't exactly in line. is there a way to fix that considering the belt symmetry? I've sometimes seen you give input shaper advice that doesn't make sense to me when you look at graphs.
untold flicker
@spring musk One of the things that is throwing off your vibrations graph a bit is the belt tension not being the same.
Does not look like a big issue in input shaper graphs.
What I would do is set input shaper to ei for both x and y.
Then using a speed in the green zone from the vibrations graph's global speed energy profile as your perimeter speed I would print a voron cube.
voron cube = 3 perimeter/bottom, 0 top/infill
post the pictures here please.
spring musk
I got this fixed. Thanks for your help!