unable to load klipper(mainsail) after input shaper install | VORONDesign | Page 1

placid horizon Jul 24, 2024, 8:10 PM

#

My pi won’t connect after installing input shaper. Is it possible to recover ? Atleast get my config file before I reinstall klipper?

potent spruce Jul 24, 2024, 8:36 PM

#

What did you do to "install input shaper"?

#

If the klipper install is broken, you can still find the config if you ssh into the pi and have a look in ~/printer_data/config

placid horizon Jul 24, 2024, 8:41 PM

#

I was following input shaper guide then installed the secondary mcu after that pi stopped working.

placid horizon Jul 24, 2024, 8:56 PM

#

there is a breif wifi signal then it goes away

#unable to load klipper(mainsail) after input shaper install