Hi, Voron 2.4 is good printer till you have met a problem. There are lots of information here and there, but they are not including so much detail. For example if you have layer shift at same height repeatedly, what should you do? If a or b motor causes vibration. what should you do? Saying that it is so hard to eliminate is not resolving issue. If you spend a lot of time and combine bits and pieces, may be you can find the problem. What do you think?
#Voron needs improved troubleshooting guide
crude karma
radiant field
this is typical the guide youll get for troubleshooting https://ellis3dp.com/Print-Tuning-Guide/articles/index_troubleshooting.html also layer shifts can be abit of a pain to solve assuming everything mechanical is fine, at that point its either too fast accels or too high run current or something thermal aswell