I am guessing the logs. How are you heating up?
#what would cause my temp target to turn off once temperature stabilize at target ?
whole stratus
wheat sinew
@whole stratus nothing at all in the logs actually. Il clear the logs tonight and do it again and see again.
Il report back.
side question, is there a way to have the time next to every line in the logs? perhaps a config somewhere?
Im turning on the hotend or bed, From touch screen or directly in browser, will do same thing both ways
have no problem printing though..
wheat sinew
whole stratus
Hmm, that is really odd. Can you attach your Klippy.log file. Also, I think it’s very odd how your temp starts that high and drops down. Klipper would normally shut down if it detects a temperature that high.
wheat sinew
actually, I found it out. it was idle time in my config.. Im a bit annoyed at myself because i spent countess hours trying to find this. and the description in in comment next to idle time, was saying minutes.. only once i went to docs read that idle time is not in minutes but in sec..