This error comes up when there should be low load on everything. My RPI is not enclosed and the room temperature is in the 60's (20's c). Printing continues but my connection to Fluidd kicks out constantly.
#Temperature limit active on 2 year old printer?
velvet iris
bleak lintel
What RPi? Does it have heatsing? Does any fan blow on the heatsink? If yes, it is possible there is not good contact between heatsing and CPU.
velvet iris
I am using a RPi 4B. No heat sink and no fan. I was told it wouldn’t need one with as little as the processor is used. I typically only see about 3% cpu usage on the RPi.
bleak lintel
There may still be other operations outside raw CPU usage which use computation power.
Who told you you do not need it? 😮
I highly recommend getting heatsink and blow some air onto it.
maiden thunder
oh. Pi4 tends to run hot. definitely get a heatsink and a fan on that thing
velvet iris
There may still be other operations outside raw CPU usage which use computation ...
A bunch of people way back when I built it two years ago. A hand full of people in the V2 questions channel.
velvet iris
oh. Pi4 tends to run hot. definitely get a heatsink and a fan on that thing
is there a specific one you recommend? should i get one with a fan attached?
velvet iris
I highly recommend getting heatsink and blow some air onto it.
would i be better off getting a RPI5?
maiden thunder
for a Pi4.... lemme find one...
bleak lintel
is there a specific one you recommend? should i get one with a fan attached?
You can, or at least bunch of those little heatsinks with adhesive thermal compound and let fan blow over it a bit.
maiden thunder
bleak lintel
If it's electronics bay, there should be at least a pair of fans
yeah that one can be good
maiden thunder
only problem with MOST of these is, if you use the GPIO for power... you will have to somehow finagle this into it...
this one too... they have an RGB version of this one I think. .. https://www.amazon.com/dp/B0B9KM9WYL/ref=sspa_dk_detail_0?psc=1&pd_rd_i=B0B9KM9WYL&pd_rd_w=9fn9G&content-id=amzn1.sym.f734d1a2-0bf9-4a26-ad34-2e1b969a5a75&pf_rd_p=f734d1a2-0bf9-4a26-ad34-2e1b969a5a75&pf_rd_r=0R276TEWQ899GVE7VTGF&pd_rd_wg=Ypl8q&pd_rd_r=4d79a835-612e-45b5-b394-ab6458013c16&s=industrial&sp_csd=d2lkZ2V0TmFtZT1zcF9kZXRhaWw
velvet iris
If it's electronics bay, there should be at least a pair of fans
yeah, i have never put the skirts on, so no fans. i just find it odd that this is a new issue
maiden thunder
not sure where you are - you have no role #rules but amazon has a number of them.
velvet iris
not sure where you are - you have no role <#869236671554682990> but amazon has ...
Sorry, I didn't know about that. Are there any other rolls I should claim?
maiden thunder
nah. just a country... it's all good. helps us help you...
velvet iris
Just received the heat sink and will install it tomorrow. Ill update the thread if it still gives me trouble