I have been trying to start printing on my Voron 2.4 300mm, however I always get some errors during QGL. When I do it without a print on, it often does not work the first time, and only works the second time. When I do it with a print, it usually tells me that the samples exceeded sample_tolerance and quits. Usually I would just try over again until it works but what worries me is that the difference between the samples can be as high as 0.05mm, which for comparison, is nearly 10 times more than the allowed 0.0075mm. Has anybody had this issue before or have any tips to try and fix it? Could it be that my probe is set incorrectly, or an issue with my motors/belts?
#Incontinuous values at QGL exceeding sample_tolerance
civic anchor
vernal jetty
I have been trying to start printing on my Voron 2.4 300mm, however I always get...
Hi, try reading Thor's post here. see if if in any way can assist. #voron_2_discussion message
civic anchor
Hello, thank you very much, I will try that