voron_2_help_forum_public
Park printhead in front insted of back after print.
Configuration
Input shaper
Tuning
Solved
Post Print issue, toolhead losing either position or steps or current?
Solved
Installing Mailsail
Initial setup
Configuration
Voron door hinges for 6mm thick panels
Mechanical
Self-source or Kit?
Initial setup
Solved
Flashing EBB SB 2209 and Initial Config... Which First?
Initial setup
Configuration
So many Toolhead combinations and choices..
Kits/parts advice
Formbot 2.4
First layer
Electronics & wiring
To ground or not to ground to frame
Electronics & wiring
Rough first layer and top layers.
First layer
Max31865 RTD input is shorted
Electronics & wiring
Sudden noise from A/B steppers when moving in Y direction
Mechanical
Heater extruder not heating at expected rate
Printer shutdown
Print looks like it's melting.
Tuning
Configuration
Trouble with Octopus Board Firmware - LDO Kit
Initial setup
Electronics & wiring
Configuration
Is This A Retraction Issue?
Tuning
First layer
No trigger on Z after full movement
Initial setup
Solved
Large gear clockwork 2 rufuses to grip filament
Mechanical
Problems after updating Voron 2.4 LDO
Configuration
Hi, any idea why my bed mesh looks like this?
Bed mesh issue
Neopixel extension LDO 2.4r2 rev C
Solved
Electronics & wiring
galileo 2 pg 7 hit the zchain
Mechanical
Electronics & wiring
ASA Prints Failing
Tuning
Voron 2.4r2: Need Software Overview
Initial setup
Horizontal lines on prints
Tuning
Troubleshooting 'Unable to Read TMC UART Register IFCNT' Error with LDO Leviathan Board on Klipper
Initial setup
Electronics & wiring
Configuration
ELI5 postion_min, max and endstop?
Initial setup
Solved
Stealthburner extruder failure
Kits/parts advice
Mechanical
X carriage moving when making manual Y movement
Tuning
Mechanical
Solved
First few layers are great. Next, spaghetti.
Tuning
Mechanical
Z Offset
BTT Controler Board Frying
Electronics & wiring
weird homing when toolhead is in the corner
Tuning
Electronics & wiring
Mechanical
Initial setup
Configuration
First layer starts great and than ends up in disaster
Mechanical
Z Offset
First layer
Tap
Configuration
honeybadger linear
Tuning
Mechanical
Kits/parts advice
What "light grease" does the printer head guide refer to?
Kits/parts advice
Mechanical
Initial setup
printing keeps having weird pattern
Tuning
Configuration
Morgen zusammen gestern habe ich soweit fahren konnen mit den achsen qgl alles ging auf einmal habe
Initial setup
Electronics & wiring
Difficulty squaring gantry
Mechanical
Initial setup
Belts vibrating and squeaking at low speeds.
Tuning
Mechanical
Solved
print head jerks to left when in one corner
Mechanical
Thermistor shuts down when I start heating up the hotend
Printer shutdown
Initial setup
Electronics & wiring
Uneven first layer even with Klicky mesh
First layer
Z needed for nozzle brush changes?
Z Offset
Unexpected Layer issues mid print
First layer
z-belt length confirmation
Initial setup
Solved
layer shift at same height
Tuning
Constant warping
Tuning
First layer
sensor or heater error
Kits/parts advice
Printer shutdown
Electronics & wiring
Scratchy MGN12H Linear Rail
Kits/parts advice
Mechanical