voron_2_help_forum_public
Switch from Stealthburner+ rapido 2 hf to XolPap+Rapido uhf - problems with flow calibration
Tuning
First print
Solved
Z axis repeatability issues
Z Offset
Mechanical
First layer
24V adressable rgb for octopus pro 1.1
Electronics & wiring
Configuration
Extrusion issues (loosing grip on filament?)
Mechanical
top layer not smooth
Tuning
Part dimensions slightly wrong
Mechanical
Solved
z artifacts
Bed mesh issue
Mechanical
Z Offset
QGL
y endstop not touching back anymore
Mechanical
weird corners
Tuning
Within 10 minutes of a print, extruder temperature starts to fall, pwm goes to 1.0, and print fails!
Printer shutdown
Print and filament extrusion failures 30 minutes into prints
First print
clogging of the nozzle
Tuning
G-STAT error on TMC 'extruder' even after much troubleshooting
Electronics & wiring
LDO nighthawk SB toolboard + phaetus rapido wiring question
Solved
Electronics & wiring
mesh configuration
Bed mesh issue
Initial setup
assembly alignment issue on ab drive gantry when trying to mount to z carriages
Mechanical
NEED HELP!!
Electronics & wiring
Initial setup
Configuration
CW2 severe underextrusion and sometimes not extruding at all
Mechanical
Solved
Electronics & wiring
Configuration
Keep out zone for z drag chain?
Electronics & wiring
Initial setup
Configuration
Problems after printer repair
Tuning
First print
is tap supposed to move like this?
Tap
Mechanical
Solved
First Print Not Printing
First print
Voron 2.4 R2 Pro+ mcu problems
Configuration
TAP Endstop Issue
Tuning
Tap
Initial setup
Configuration
Very dirty print, size mismatch
Tuning
Mechanical
First print
Formbot panel mounting
Kits/parts advice
Can't get sensorless homing working
Initial setup
LDO Screw Hinges Assembly Orientation
Initial setup
Extruder would stop extruding after some time
Tuning
Mechanical
Electronics & wiring
Configuration
Inconsistent z-offset across the bed
Z Offset
2.4 350 does not power on anymore
Electronics & wiring
LDO Kit Rev A/B toolhead board to LDO Nitehawk boards
Kits/parts advice
Electronics & wiring
Odd gaps at layer starts
Tuning
SB2040 / CAN Bus problems
Solved
Electronics & wiring
Configuration
ADXL345 wiring on Pi with LDO Leviathan Main board
Tuning
Kits/parts advice
Electronics & wiring
Configuration
QGL problems
Kits/parts advice
Initial setup
QGL
New Voron 2.4 Startup Help
Electronics & wiring
Galileo2SA known issues? Sudden underextrusion/skipping during prints
Tuning
Formbot kit missing part. It is used instead of Wagos. I am not sure what it is called.
Electronics & wiring
suddenly my printer does not start
Printer shutdown
Configuration
[Solved] LDO Voron 2.4 - steps needs 45 rotation distance
Mechanical
Solved
Timeout with MCU 'EBBCan'
Printer shutdown
Electronics & wiring
I’ve asked this question before and I think you’ll know better the answer
Kits/parts advice
[SOLVED] LDO 350 - Bed centred on X but 0 and 350 positions are off
Mechanical
Initial setup
Solved
what’s this sound when I move the tool head around?
Mechanical
Solved
Y Axis Not Homing Properly
Initial setup
Old PIF parts compatibility
Kits/parts advice
inconsistent layers
Tuning
Solved
None of my fans or the case lighting LEDs work anymore, and more. LDO 2.4C
Electronics & wiring
Config File Help
Initial setup