#my pc just came today and everythings plugged in, but when i turn it on, the OS doesn't load

12 messages · Page 1 of 1 (latest)

distant pewter
#

i hear three beeps and then nothing, please help!

tough basin
#

how many long/short beeps?

distant pewter
#

1 long beep and 3 short beeps

subtle sun
#

Try reseating your ram sticks and rebooting the pc to see if that fixes the issue

thin prawnBOT
#
Reseating RAM
distant pewter
#

now getting 1 long beep and 2 short beeps

subtle sun
#

Try resetting your cmos

thin prawnBOT
#
Resetting CMOS

:one: Shut down your PC and unplug the power cord from the wall.
:two: Locate the CMOS battery (see the image below). On some motherboards, you may have to remove the graphics card in order to access it.
:three: Remove the CMOS battery from the motherboard by pressing down on the clip and pulling the battery out.
:four: Hold down the case power button for three seconds while your PC is unplugged.
:five: Install the CMOS battery back into the motherboard and plug the power cord back into the wall.
:six: Plug in and turn on your PC.

A video guide is also available below

distant pewter
#

no luck sadly

subtle sun
#

Could try reseating your gpu

thin prawnBOT
#
Reseating GPU
#
Base 64K RAM Failure

There is a failure of some sort within the first 64KB of system memory.

The first bank of memory probably has a bad memory chip in it somewhere. It is also possible that there is a failure related to the motherboard or a system device as well.

Nvidia RTX 30 Series GPUs:
Try disabling CSM (Compatibility Support Module) in your BIOS, and make sure the boot mode is set to UEFI.

ASUS Motherboards:
1 Long + 2 Short: Anomaly detected in RAM.
1 Long + 3 Short: Anomaly detected in Graphics Card.