hazy owl
This board has two motor-controller that can controll 2 steppen drivers like the NEMA17. Or 2 individual motors. Reverse/Forward/Brake and you can alter the power.
In a project I use for a device two dc coils and for the other a steppendriver. I also need to very carfully measure the voltage on a special sensor.
molten current
Why did you choose the ESP32-C6 ? just curious, any support issues youve noticed?
ashen venture
Which stepper drivers do you use?
hazy owl
Why did you choose the ESP32-C6 ? just curious, any support issues youve noticed...
Because the matter support it has
zigbee mainly, however didnt get it to work yet
adc is really hard to get supported in esphome
basically not
but the external does
the 2 steppen drivers can also control dc motor because of the two h-bridges
arctic prawn
I'm struggling to get esphome and any of my esp32-c6 dev boards working with ardurino or even esp-idf. Were you able to make progress with esphome? If so, would you be willing to post your YAML?
dire bloom
I'm struggling to get esphome and any of my esp32-c6 dev boards working with ard...
For C6, I think you need idf. Have you looked in the #1062229382275530762 thread?
arctic prawn
For C6, I think you need idf. Have you looked in the <#1062229382275530762> thr...
I'm new here, but I just found the ESP32-C6 thread. Looks like a goldmine! Feel like I'm so close to having working config, yet so so far away 😩
hazy owl
Adc in C6 still doesnt work
dire bloom
I thought that was fixed? Or there should at least be a PR.
hazy owl
Really since when