[💡] Stabling sensor not applying shunting commands to trains completing leg at terminal station

[strange sphinx]

Stabling sensors built at terminal stations are not applying their shunting commands to regional trains completing a leg at the station, nor are they being reversed.

Manually reversing and shunting the trains works as expected.

The train not reversing seems to only a problem if a departure sensor is also built on the platform.

I have not yet seen this issue on non-terminal stations (e.g., Holesovice in Prague).

Game version: 2.1.21
OS: Linux

Steps to reproduce:
From scratch:

1. Start a new Prague map with everything unlocked
2. Build a route to Masaryk and a shunting loop for reversing a regional train
3. Build a stabling sensor on the platform with default settings and commands to reverse a train
4. Accept a regional contract with a leg terminating at Marsaryk
5. Observe the train stopping at Masaryk and not receiving shunting commands
   With my save:
6. Load the attached save file
7. See that platforms 2 and 4 at Marsaryk have default stabling sensors with shunting commands
8. See that two regional trains Reg743A0 and Reg225A3 are about to arrive at platforms 2 and 4 (respectively).
9. Despite the presence of stabling sensors on both platforms, neither train receives the shunting commands or reverses, instead stopping at the end of the platform.

Wrong behavior:
Regional trains finishing their leg at a terminal station are not receiving the shunting commands from the stabling sensor, nor are they being reversed (if a departure sensor is present).

Expected behavior:
Regional trains finishing their leg at a terminal station receive the shunting commands from the stabling sensor.

Screenshot:
Marsaryk Sensor Setup.png shows the stabling sensor setup at Marsaryk station.
Regional Trains Arriving.mp4 shows two arriving trains not being given the shunting commands.

Save:
prague_Stabling Sensor Not Working Example_22-35-59_2f4ec.mp.lz4 has been set up to show the two arriving trains from the attached video.

Log:
Player.log is attached.

[sour yoke]

You have to put the stabling rule on the signal the train is currently heading towards when entering the platform. I.e the dead end signal on terminus stations.

[strange sphinx]

Yes that has fixed it. I didn't know that was possible since the station doesn't come with signals on the dead-end by default. It's been a while since I last played and I don't remember having to set the sensor up this way before. Thanks for your help