help-feedback
Wavy cuts without a bandsaw
Murphy Table/Bookshelf
Design
screw issue
are these black spots mold/mildew?
Where to get wood "lumber" below 3cm thickness?
Purchasing Advice
Inexpensive CAD Options?
Not About Wood
Purchasing Advice
So what is a good angle for end grain?
Tapered sliding dovetails with/without shoulder
Technique
dowel
3d into 2d?
Linkage Salt Cellar
Design
Opinions: Should I use Dovetail grooves or T Track for my drill press table?
Pegboard question
Hinge for recessed lid
Help making a tapered bowl without a lathe
Design
Technique
Tricky Barstool Seat Curves
Technique
Repair
Looking for Suggestions on my first project
Design
desk drawer support with glue up
How to get ride of this soft runny blobs
Finishing
winter shop
how do i remove these marks
Removing wheels and extending legs on workbench.
Need some help from cabinet makers. How to display cutting information.
Shoe bench design feedback
Repeatable Long Dados on Table Saw
Alternatives to Birch plywood for 1300x900x600mm boxes holding a substantial amount of weight inside
making my own wipe-on poly without mineral spirits?
miter/frame clamping jig
A reach...
Whats your favorite method to cut plywood without blow out?
Which hand-tool to use for nonlinear cuts in semi-thick wood?
Not About Wood
Technique
Ideas for fixing misaligned bolt holes in bench
Dowel jig for bevel waterfall edge
finish storage feedback
What'd be the best way to fill this hole on the very very cheap?
Repair
Pondering first leaf table, slides, any tips or cautions? Want to build gaming vault between slides
is this orientation the best way to stop warping after glue up?
Need a 1 1/4" CL 1/2" DIA 1/4" SHANK spiral bit (preferably down cut)
Soap on Shapton / Flattening on sand paper
Not About Wood
Technique
selling this rockwell 34-350 idk what I should sell it for
What tool to use to cut straight edge into chisel back?
Technique
Not About Wood
Edging on a kitchen cabinet door
shapton 12k on lie-nielsen 5-1/2
How should I think about this end grain when face laminating
Question with a bending / sagging table
trouble with getting that perfect finish
Easel pro xcarve
Where is the inch on the inch line of a measuring tape
I have a 3 foot (give or take) ovular branch, how can i evenly drill a hole through it?
lighted sign for my yard