#B350-F rog strix, not working?
1 messages · Page 1 of 1 (latest)
does or does not get into the bios
does not***
if it does not post take out all sticks of ram
then put one stick in
see if that posts
Tested one stick, in all the slots one by one
and it does not do it
no :/
what is the light code on the mobo?
no light code, other than "orange dram, red cpu"
and stays red cpu
Tested two cpu's (1800x and 2600X) that works
okay sounds liek a bad cpu or socket take the cpu and look for bent pins
sounds liek a bad cpu
No bent pins, even did spray electro cleaner down the cpu socket and let it dry (even blowing air so all the cleaning would waporate)
evaporate*
Can be dmg on the socket pins? (mb socket)?
hmm mby..
it instanly as I turn it on spin the fans, light up a some random leds on the motherboard and tries to do a start. witch give "orange dram light goes off, red light cpu comes and stays"
so it looks like it is trying
check to make sure you plugged in all the ower cables both the 24 pin mobo and 8 pin cpu
They are fully plugged..
okay
little lost tbh, can it be bios crash?
did it used to work before?
I got it for cheap from a guy that had upgraded from a 1600 to a 3600 and didn't get it to post
So I guess it was an old bios.. so I did buy it
ye, so I tested with a 1800x and a 2600x I have.. and they don't post
so probly something more, I've build a few computers and like to troubleshoot
i think the board itself might be bad do you know if the cpu work in other systems
but I don't have anything to read bios with
i dont think it is a software issue
ye, both cpu's work on my other mb
ok does the ram work in other systems
I have not tested the ram I used first.. but I have tested a 16GB stick and that did not work
give me two sec I'll boot one of the 8gb 2666 sticks on my testbench
yup
ye the ram is fine
okay
so both the cpu's u tried and the ram u tried are good both power plugs are firmly seated and you still get lights it sounds to be like the board is deader than a door knob sadly
wheather it happened in shipping or the seller knew it
what do you have any storage pluged in if so take it out see if that makes a different
no storage.. I only test with mb, cpu, 1 stick of ram, and stock cooler plugged in cpu fan.. and start the system with a startbutton
yeah did u try clearing hte cmos?
ofc clearing cms everytime just for the sake of it, and even clearing if I swap ram slot
ye, 30++ sec with a jumper plug
i would take the battery out and leave it out
then boot with no cms battery?
yeah take the battery out leave it out and put the jumper into clear cmos mode and powercycle it
I'll try that tomorrow otherwise i'll just sell the board as defect and then the next guy can try