#SLZB-06M will not connect

1 messages · Page 1 of 1 (latest)

viral palm
#

Heyo. I had my SLZB-06M working previously. Only one Zigbee device connected. But then my router's firmware corrupted and I had to factory reset it. Since then each time I try to add the SLZB-06M to HA I get this error: "Could not form a new Zigbee network. Error:"

Any assistance would be greatly appreciated!

image.png
#

And if I ask it to use a Advanced install I just get this

image.png
# 
[12.02.2026 18:34:01] SocketServer | [EFR32MG21] New client, id: 0
[12.02.2026 18:34:11] SocketServer | [EFR32MG21] Client disconnected, id: 0
[12.02.2026 18:34:14] SocketServer | [EFR32MG21] New client, id: 0
[12.02.2026 18:34:35] SocketServer | [EFR32MG21] Client disconnected, id: 0
[12.02.2026 18:36:05] SocketServer | [EFR32MG21] New client, id: 0
[12.02.2026 18:36:15] SocketServer | [EFR32MG21] Client disconnected, id: 0
[12.02.2026 18:36:31] SocketServer | [EFR32MG21] New client, id: 0```
viral palm
#

Or sometimes it just sits here for actual hours

image.png
viral palm
# 
[12.02.2026 19:01:10] SocketServer | [EFR32MG21] Client disconnected, id: 0
[12.02.2026 19:01:10] SocketServer | [EFR32MG21] New client, id: 0
[12.02.2026 19:01:25] SocketServer | [EFR32MG21] Client disconnected, id: 0
[12.02.2026 19:01:34] SocketServer | [EFR32MG21] New client, id: 0```

Still no change in the logs. It's now 21:57 and it's still showing this:
image.png