Shelly Mini Gen4 wiring

[smoky kite]

Hello!, I have 2 switches that connect to each other that control the same lighting circuit. I was wondering how I should go about wiring them. I would like them to act as "dummy switches" for my smart bulbs. The primary switch has 2 lives and 2 neutrals whilst the secondary has 1 live and 1 neutral. I am in the USA

I only was able to find 1 diagram for my situation but it's for south african circuits :/

[hasty quiver]

there are multiple ways that dual switches can be wired. can you diagram how things are wired in your setup?

[smoky kite]

The breadboards are the switches, I only had TinkerCad so i couldn't do switches. Red is Live and Gray is Neutral

[hasty quiver]

this makes absolutely no sense...

[smoky kite]

Sorry, looking back it doesn't

It's essentially a 3 way switch setup like this:

[hasty quiver]

this is not a wiring diagram.

[smoky kite]

I understand, I am drawing one

The First outlet is wired with Hot on top and neutral on the bottom on the right, this is from the light, the second outlet is wired from the otherside of the switch and is Hot on top and neutral on the bottom. If this doesn't make sense I sincerely apologize, I am a programmer who normally doesn't deal with electrical. I will send a pic of my switches tomorrow when I can open them up again

[hasty quiver]

honestly at this point. you should seek a professional electrician to help.
I think you fundamentally misunderstand how things are wired and are working on false assumptions.
Mains electricity is dangerous, It can and will kill you.