lunar heart
I just got a Shelly BLU TRV to control the heater of my house, and after I connected with HA, the temperature readings are always going back to a certain level. I tried to set the external temperature from HA, and the temperature offset directly in the device, but neither seem to help. See graph attached.
Any directions?
Thank Thanks!
teal dock
Can you post the legend for that graph?
Your question doesn't really make sense and the graph looks normal
lunar heart
Here’s the graph with the legend.
So, the issue is that it was saying the current temperature was 0 degrees, while I was in the room and the temperature was not 0 degrees…
Before connecting to HA, the temperature showed 21 degrees, which seemed reasonable, and after that, it started to go to 0.
I removed the device from the heater, as it was trying to heat the room al the time and it was quite warm, therefore the graph stops to have this orange/red part which indicates its heating
teal dock
Here’s the graph with the legend.
So, the issue is that it was saying the curren...
What is the device reporting in shelly? At the same time, what is the device reporting in HA? If those differ, this could be a bug in the shelly integration. If they are the same, you just need to apply an offset. Most temperature sensor hardware offers that ability at the hardware level, and that's where you should be altering it.