#Matter over thread USB stick
1 messages · Page 1 of 1 (latest)
I have 2x https://a.co/d/7Exrs7j one for zigbee and one for thread, seems to work fine
Powerful MG24 Chip Upgraded EFR32MG24 chip delivers stronger performance, handling complex gateway tasks with improved stability and speed. Enhanced Signal with 3dBi Antenna High-gain antenna provides stronger signal and wider coverage, reducing disconnections and ensuring reliable device connect...
was it complicated to configure the matter protocole? How do you connect devices?
If you are using HAOS, it's pretty straightforwards, although depending on the specific USB stick you use you might need to flash the firmware to thread using a web browser first. The general instructions are here: https://www.home-assistant.io/integrations/thread/#adding-a-third-party-thread-adapter-to-home-assistant
for adding devices, follow the steps here: https://www.home-assistant.io/integrations/thread/#to-make-home-assistant-your-first-thread-network
depending on how your home network is set up you might run into issues setting up matter devices. specifically, if you use vlans or have Unifi network equipment you might need to do some extra troubleshooting to figure out why things can't talke to each-other.
If you're not using HAOS then things are much more complicated.
Are there any Antennas/Sticks which supports Tigbee and Matter at the same time? Does the ZBT-2 do?
The Sonos does, however it's not really supported by HA