#Bilresa Dual Button and Home Assistant Erratic button configurations

1 messages · Page 1 of 1 (latest)

native dagger
#

I recently purchased some Bilresa Dual Buttons from Ikea and have them setup over Matter.

I found a blueprint that helps with getting the buttons to be accessible.

Upon adding the buttons and testing I noticed that it works fine.

The issues I have is sometimes, the device will not read as if it's in deep sleep mode even when you press the button the device can take anywhere from 30 seconds to 30 minutes for it to react. After the device is awake it functions like normal.

Has anyone come across this issue?

I was checking to see if there's a state wake or anything that can help with waking the device faster but I can't seem to find anything.

native dagger
#

resolved I factory reset the button and works flawlessly now

snow briar
native dagger
#

Open the button to gain access to the batteries. There's a button in the middle next to a tiny hole. Hold down on that button and the hole will begin blinking red, keep holding until the red light goes solid then release the button.

snow briar