I've initiated an OTA update through home assistant for my zooz door/window sensor, and it hasn't finished after over an hour. This is my first Z-Wave device, using the ZWA-2 dongle.
#Z-Wave OTA update taking over an hour
warped zenith
After another 10 minutes, the update seems to have been completely forgotten? Home assistant is no longer showing the update as in progress, but is back to saying there is an update available (the one I was trying to install, namely 2.10.0 -> 2.20.0)
raw stump
I had to wake my door sensors to get them to recognize there was an update to process. My door sensors are Aeotec though. Was it just the blue bar going across the progress bar or were there white dots? When my devices were asleep it was a blue bar. When the update actually started to process it showed white dots.
idle crescent
ota update can take ages..
warped zenith
I had to wake my door sensors to get them to recognize there was an update to pr...
Ah so there was an actual progress bar? I only got the indeterminate one, so it probably never started and just timed out at some point.
idle crescent
i've waited for a couple of hours to complete OTA firmware update, advice=patience 😉
raw stump
Ya it'll turn to white dots. I had the same thing for a while. I had to long press mine to wake them up. Are these your sensors? It looks like 4 quick presses to wake them? https://www.getzooz.com/downloads/zooz-700-series-z-wave-plus-open-close-xs-sensor-zse41-manual.pdf
warped zenith
After another 10 minutes, the update seems to have been completely forgotten? Ho...
Sure but as I mentioned above, it "cancelled" at some point
idle crescent
reboot/retry