Hi, I have a HomeAssistant voice assistant. I had to reset it to factory settings by holding the button. It reset, but how do I add it now? HomeAssistant doesn't show a new device.
#Voice Home Assistant Nabu casa
trim spire
waxen star
remove voicePE from HA (if present) then reboot VoicePE and reboot HA. Usually it will pop up as discovered device again.
trim spire
remove voicePE from HA (if present) then reboot VoicePE and reboot HA. Usually i...
What voicepe?
I removed the device from esphome integration and esphome builder
waxen star
have you removed the yaml in esphome< if not, do so and reboot, not restart
trim spire
have you removed the yaml in esphome< if not, do so and reboot, not restart
i do...
waxen star
what assistant do you use?
trim spire
default
waxen star
what device did you reset?
waxen star
Well that's teh VoicePE 🙂
1 moment, i'll share link to reflash it.
after successful reflash it should re-appear
trim spire
Okay, wait. I try
And with it added to EspHome Builder, can I add any triggers to the EspHome automation? For example, to control the LEDs in a room relative to the assistant?
waxen star
if you have the device up&running, you could add the entities you want to be control by voice by exposing them to your assistant.
trim spire
Because I currently have automations done for entities
waxen star
Good to hear it's working!
Note that you have to expose the entities to the assistant
trim spire
What I mean is, I want to mount this assistant in the ceiling. I'll print a slightly different housing and mount it in the middle of the room, as it has good microphones. I'll connect the speakers via a jack input. I also have addressable LEDs connected after integrating WLEDs, and I'd like to control what the assistant is doing: whether it's listening, responding, thinking, or if there's an error.
waxen star
That should be doable, yes. But that would be an #1284966540617449515 thing (new thread) or, if no futher questions you may close this thread as resolved by checking the resolved box.