sweet sky
after a disastrous updating process of my Qubino smart plugs, I have everything going again, except for one detail, they have a huge negative usage:
I did try to reset various values and derivative entities, but this keeps bugging me.
Ive thought of factory resetting them and start all over, but, wouldn't the history/longterm stats of these devices be overwriting the factory setting, leaving me where I was to begin with?
chilly python
Does your device have a button in the Z-Wave panel "reset accumulated values"?
sweet sky
yes!
ok so here's a first 😉
back to 0 kWh.... too bad to see my many years accumulation get lost now, but it is what is is, and that silly negative number wasnt anything to go forward with....
now I have only silly things and obvious impossible readouts like this to take care of....
chilly python
Shhh. Hide your fusion reactor
simple citrus
now I have only silly things and obvious impossible readouts like this to take c...
In the developer tools under statistics it will find and flag outliers to clean up
sweet sky
Sure, but it is so tedious… don’t think it will ever be truly reliable unless wired
sweet sky
right, so I thought this was fixed, but now ook what happened
it went from negative to positive.... on these 2 devices, the others seem ok now
somehow even the reset accumulated values button disappeared from the device entities, so I re-enabled it and clicked once again. Back to 0 for now, let's see what happens
unresolving the thread because of this
chilly python
Are they included with encryption?
sweet sky
No, I’ve never used encryption in Zwave
chilly python
That would prevent such packet corruption.
Unless the devices measure something unrealistic, it's likely due to noise near a repeater or the controller.
sweet sky
is there a possibility to re-included those devices with encryption?
chilly python
If they support it, then exclude and include them again, with encryption. You may have to force S0