fervent jackal
Hey, I've just wired an ESP C6 with an LD2450 and while I get results and can see movement with the sensor, the results seem to be all over the place and Im not sure if its just me, a defect sensor, or if the sensor in general is bad.
When using the bluetooth app to see the detection, the circle for persons seem to almost perfectly always are in a line. E.g. when we are two persons, one is shown as 3m and 7° degree the other is 7m with 6.8° while in reality we are like 2 and 3m away from the sensor and are like 3m away from each other. Even when I walk from complete left to complete right of the sensor it looks like the detection zone is much much smaller than what I assumed it would be. And the angle in the app only moves from 7° to like -1°. I assumed it will go from 60 to -60° or so. I've attached a screenshot with an example (not my detection, pic from google, i've just added the red markings). It looks like only the red zone is detected.
Im wiring the LD2450 from the 5V pin of the ESP. And since I at least get a result, I assume that the rest wiring is also ok.
So my question: Is the LD2450 this bad? Do I have a broken device? Is my setup wrong?
