cyan hazel
Hey guys, I recently started putting power metering hardware any place I could and I am quite confused about why the following is happening.
I have a shelly that measures the entire garage, inside the garage I have two printers that each have a power metering plug.
I setup the plugs to have the garage shelly as an upstream device, and this works well in the top graph. However the bottom graph still shows the entire energy measured from the shelly, it doesnt subtract the two printers there.. Is this intended? It is really confusing since the bottom graph totals to more energy than actually used, while the top one is accurate..
Is there a way to change this?
TIA! :)
wraith sparrow
spice burrow