Controls not showing up for Yale Lock using Z-Wave USB Stick

[pallid osprey]

I've configured my Yale lock using a Z wave usb stick module, and when I go to my devices, I see my Zooz controller and Yale lock. However when I go to my Yale device, I don't see any options for controls for unlocking or locking. I thought I had properly put it into pairing mode by clicking 7 and accessing a wireless network. The zwave HA resource showed me I connected, how can I best trouble shoot this?

[half vault]

You likely did not connect it with s2 authentication. You may need to reprovision the lock with security enabled.

[pallid osprey]

reprovision the lock as in factory reset it?

[half vault]

Disconnect from home assistant, then reconnect correctly. You don’t need to factory reset to do that.

[pallid osprey]

Could you expand on the s2 authnetication, its a Yale lock and per online tutorials I just go to the wireless connectivity toggle which is #7 on the lock keypad and attempt to connect to the Z wave usb stuck

[half vault]

https://www.home-assistant.io/integrations/zwave_js/

go here and scroll to “removing a device from the zwave network”, do that first. Then re-include the lock following “Adding a new2 device to the zwave network” in the same doc. When you’re including I believe you need to check a box to add the device using s2 security if the device is older.

[pallid osprey]

Thanks for your help. I did nothing different but removing the lock from the zwave network and then re-adding it somehow gave me the ability over controls lol? Wish I had a better solution in case I ran into it but i guess turn it off and turn it back on worked lol.