Remote Access seems to break when IPv6 enabled on my HA server. | Home Assistant | Page 1

subtle echo Mar 26, 2025, 2:42 AM

#

So this has happened a few times and I spent a lot of time troubleshooting, but whenever I have IPv6 setup on my Yellow, Remote Access inevitably stops connecting at some point. And I have verified that the IPs (v4 and v6) on my systems haven't changed. If I disable v6 remote UI access is restored and it's actually driving me a bit insane now. 🙂 If it just completely stopped working when it was enabled I could work with that, but it does work for some random amount of time (this last time it was good for over a month) then it just hung.

Does anyone have any suggested config or testing I can do to get a bit deeper into why this is happening?

hard nova Mar 26, 2025, 2:48 AM

#

subtle echo So this has happened a few times and I spent a lot of time troubleshooting, but ...

Not saying you wont be able to get help here but you can also submit a support ticket here - https://www.nabucasa.com/support/

subtle echo Mar 26, 2025, 2:48 AM

#

I am tempted, I opened one a while ago but didn't have the "v6 inevitably breaks" info to add to it. Thanks.

onyx estuary Mar 26, 2025, 12:01 PM

#

Odd, because I have Starlink, which is native ipv6, and only does ipv4 through CG-nat, and everything just works. I use ipv6 internally too.

old lintel Mar 26, 2025, 3:34 PM

#

I am having the same issue. I can not reach Remote Access. I disabled IPv6 and it worked for a while then I lost it again. I also just tried Rebooting the system which also worked for awhile but now is not again. I sent in a support ticket last night and followed it up again this morning when I lost access again after disabling the IPv6.

#

This just started for me after working fine for months. Not sure if it matters but I did update to HA OS 15 and HA Core 2025.3.4 recently

#Remote Access seems to break when IPv6 enabled on my HA server.